11
·
Connect the USB plug to your laptop and the RS485 plug to the laser module
interface cable
·
Connect the power supply to the interface cable
·
Connect the interface cable to the laser module connector
·
Start the READYBeam software
·
Now it is possible to control the lasers via the software
2.2.5 Software interface
1. Set
Modulation Mode:
choose «Digital»
2. Set
Power Value 1
(red),
Power Value 2
(green) and
Power Value 3
(blue):
values in % of the max. laser power
3.
Switch the Laser on/off with
Digital Enable 1, 2 or 3
4. Enter the command with «
Write Config
»
Button
The READYBeam software is provided for download at
fisba.com/readybeam-software
2.2.6 Analog controlled operation
·
Connect the power supply and signals according the pin configuration on
Table 1, page 12
·
Connect the Interface cable at READYBeam
·
Switch ON +12/+24V Power
