FirstStreet Scootle, User Manual

Page: 13 / 22

- 22 -
CRUISE CONTROL
When cruise control is activated, the scooter automatically maintains the stored speed.
To use Cruise Control:
You can operate cruise control at variable speed with pushing cruise button “ W ” and the
indicator “ Y ” will be light on.
To turn off Cruise Control:
Briefly push cruise control button “ W ” or pull down the speed
lever “ S ” then release immediately.
● Use cruise control only if road and traffic conditions make
it appropriate to maintain a steady speed for extended period.
● Always pay attention to traffic conditions even when cruise control is activated.
● Cruise control is only an aid designed to assist driving. You are responsible for the
scooter’s speed and brake at all times.
Do not use cruise control:
● In traffic conditions which are not allowed you to drive at a
constant speed, e.g. heavy traffic, winding or bumpy roads, where
may cause an accident.
● On slippery roads, the drive wheels may lose their grip when braking or accelerating
which may cause the scooter to skid.
● When there is low visibility, e.g. due to fog, heavy rain or snow.
● Cruise control may be unable to maintain the stored speed on uphill gradients. Hence,
do not use cruise control when the slope gradient is of 4 and or 4 degrees.
● Do not use cruise control when riding down hills or down inclines.
- 23 -
If the scooter does not move after the re-set, one of the following
indicator lights may be displayed:
The magnetic brake either turn off or connectors are loose.
Batteries on scooter for recharging with the key switch turn on.
Low voltage of batteries detected.
Potentiometer fault.
Overload protection.
Battery needs recharging or connection fault - check grey
color connector.
Unusual current output.
AUTO SWITCH OFF ELECTRONIC SYSTEM
● The electronic system of this scooter is protected by a digital over current cut-off
system. If your Scootle stops, you will need to turn the main key switch to the “Off”
position, and then switch to “On” position to reset the system.
● Possible causes of over current cut-out are battery not fully charged or near the end of
its life, or the slope is too steep for the scooter. Do not continue to overload the system
as this may damage the controller.
● The electronic system of this scooter will switch itself “Off” after 3 minutes if the key
switch is left in the “On” position when the scooter is not in use. You will then need to
turn the key switch to the “Off” position, and then switch to “On” position to reset the
control system.
Green light flashes quickly
Yellow & Red light ON
Green light flashes slowly
Green, Red & Yellow light
ON
Red & Green lights
flash alternatingly
Red light on
Yellow light flashes
quickly