Multi Sensor Solution
https://.install.myfirstech.com
DASII
Programming
Guide
Copyright 2021 Firstech, LLC DASII Programming
Page
3
FT-DASII (Digital Adjustable Sensor gen II)
The DAS II has a built-in accelerometer that monitors sudden movement forward or backward
during the remote start process when starting a manual transmission vehicle. DAS II
ACCCELERAMETOR DOES NOT WORK IN AUTOMATIC TRANSMISSION MODE.
The DAS II also includes a dual stage impact sensor, and auto adjusting tilt sensor, and glass break
sensor all in one. Follow the steps below to properly setup your DAS II sensor levels. You can view
our programming/ demonstration video located in our video library at www.install.myfirstech.com.
Pre Installation Notes:
- Make sure to mount the sensor before testing, we recommend a solid - semi solid surface
centrally located in the vehicle for the best results.
- Always fully test each sensor before delivering the vehicle.
- For more accurate testing make sure all the windows and doors are closed before you begin
testing
DAS-II Programming Procedure (NON DC3 CM)
STEP 1:
Turn the ignition to the ‘on’ position
STEP 2:
Send Unlock command 2 times (unlock => unlock) using any Firstech remote
or OEM remote
(capable of Controlling the CM through data module)
At this time the
DAS-II display will initialize and stay powered up for at least 5 minutes or until ignition
is off.
STEP 3:
Push the programming button repeatedly until the desired sensor has been
selected 1-5 shown in the table below.
(
The programming button will be used to navigate
the sensor adjustments and sensitivity once a sensor has been selected.
)
STEP 4:
Once the sensor has been selected hold the programming button for 2 seconds
to confirm selection and enter sensitivity adjustment. The adjustment options will now be
accessible with default setting displayed. (Sensitivity options will be shown in table
below.)
STEP 5:
push the programming button repeatedly until desired sensitivity level is
reached
(setting 0 will indicate sensor is OFF => except option 2 window break
sensor conditions)
STEP 6:
Hold programming button for 2 seconds to save sensitivity setting. After the
setting is saved the sensor will start over at sensor 1 again.
(if the programming button is
not pressed within 5 seconds after setting the LED will flash 2 times save the setting
and exit that sensor programming)
STEP 7:
Programming completed, turn vehicle off, close all windows and doors and
begin testing
Summary of Contents for DASII-2021
Page 1: ......
