Vibrate to settle concrete.
3. Make sure post is straight and plumb. Brace while drying if necessary. Allow 24 hours minimum drying
time before continuing assembly. Place 4” square post cap on top of pole.
4. Using
½
” x 4” U-Bolts, lockwashers and nuts attach the extension arm support to the vertical pole either at
desired rim height or at ground level. If you choose to bolt extension arm support up high first, the bottom of
the extension arm support should be bolted 93
½
” up from playing surface.
5. Loosely attach all four extension arms to the extension arm support using
½
”x 11” hex bolts,
½
” nylon
flatwashers and hex nuts. (The short extension arms go on top and the nylon flatwashers go between the
extension arms and the extension arm support to prevent paint rubbing)
6. Using the 5/16” hardware provided with your backboard, bolt the I-Frame Backboard Mounting (as shown
in Figure B) to the center four holes located at the top of your backboard. Remove and discard the plastic
shipping block located at the backboard joint
7. READ THIS ENTIRE STEP BEFORE PROCEEDING: Attach desired rim loosely with the hardware
provided in the rim box. Rim should bolt through backboard and into I-Frame.
ATTENTION:
If your
backboard is
ACRYLIC
(FT210, FT215 or FT220) be sure to sandwich one black rubber gasket (provided
with backboard) between the backplate of the rim and the face of the backboard and the other gasket
between the Backboard I-Frame support and the backside of the backboard when attaching rim. Trim
gaskets if necessary.
ATTENTION:
If your backboard is
TEMPERED GLASS
(FT216 or FT221) your
backboard should have (4) aluminum core grommets inserted into the glass where the rim bolts through. If
they are not in the backboard, look in the box, they may have fallen out during shippping. If you cannot
locate all four aluminum cores, DO NOT PROCEED WITH ASSEMBLY, call First Team immediately,
1-888-884-6677.
8.Using the 5/16" hardware provided in the bolt bag, attach the I-Frame bottom angle to the bottom four
holes in the backboard aluminum frame as shown in Figure B.
9. Attach the Backboard/I-Frame/Rim assembly to the lower set of arms using a
½
”x 11” hex bolt and
locknut. Use one nylon flatwasher between both extension arms and the I-Frame backboard support to
prevent paint rubbing.
10. Attach upper set of arms to the Backboard/I-Frame/Rim assembly using a
½
” x 11” hex bolt and locknut.
Use one nylon flatwasher between both extension arms and the I-Frame backboard support.
11.Tighten all bolts except where extension arm support mounts to the vertical pole. Make sure rim is
square with the backboard, etc.
12. If you are working at ground level, slide the entire assembly up the vertical post until the bottom of the
extension arm support is 93
½
” above the playing surface. Make sure entire project is level and square,
tighten U-Bolts now. IMPORTANT! Do not overtighten U-Bolts, this can cause damage to the extension
arm support. Just tighten U-Bolts until they are snug.
13. Using a
½
” x 4” U-Bolt, lockwashers and nuts, attach the Crank Bracket to the back side of the vertical
post so the bottom of the bracket is 61 1/4” above the playing surface, tighten it now. Do not overtighten
U-Bolt.
14. Using a
½
”x 11” hex bolt and locknut, attach the Crank Assembly to the holes furthest back on the lower
extension arms as shown in Figure A. Note: While attaching the crank assembly you must simultaneously
