“DOUBLE-CLICK”
The Tomahawk has a program feature that helps prevent the accidental
discharge of white light when operating in low light scenarios. While in
Lock-Out Mode the secondary LEDs can be turned on by double-clicking
the On/Off button. This allows quick access to the low-level color LEDs,
while disabling the Momentary white light button. Once the LEDs are
turned on, the brightness can be adjusted using the Cycle button. To turn
off the secondary LEDs, press the On/Off button once. The light is then in
the standard Lock-Out Mode and can be switched to either White Light
Mode or IR Mode by following the steps in the instruction manual.
MOMENTARY MODE
To operate at maximum brightness, depress and hold the elongated
Momentary Control. When released, the light will turn OFF.
CYCLE CONTROL
The Tomahawk NV is equipped with a ring of color that includes visible
red LEDs as well as the Infrared (IR) night vision LEDs.
With Light in READY mode, activate the visible RED LEDs by pressing
and releasing the Constant-On Control quickly. The visible red LEDs will
illuminate. While illuminated, press and release the Cycle Control quickly
to change brightness level(s).
While operating in any VISIBLE color or white light setting, pressing the
elongated Momentary Control will override into the maximum white light
brightness
CONSTANT-ON MODE – WHITE LIGHT
To operate in White Light Constant-on Mode, depress and HOLD the
Constant-On Control until the light emits white light then release. To turn
off the light, press and release the Constant-On Control again.
The Cycle Control will allow for brightness level adjustment while operat-
ing in White-Light Constant-On mode.
PRESS AND RELEASE THE CONSTANT-ON CONTROL FOR THE
RED LIGHT, PRESS AND HOLD THE CONSTANT-ON CONTROL FOR
WHITE LIGHT.
WHILE OPERATING IN CONSTANT-ON MODE (IN ANY COLOR AND
BRIGHTNESS SETTING), PRESSING THE ELONGATED MOMEN-
TARY CONTROL WILL OVERRIDE COLOR WITH WHITE LIGHT AT
MAXIMUM BRIGHTNESS.
When the elongated Momentary Control is released, the light will return
to the previously selected color and brightness level.
NIGHT VISION (INFRARED/IR MODE)
The Tomahawk NV is designed to eliminate the risk of accidental illumi-
nation of visible light when operating the infrared LEDs. A control
sequence is required to enter and exit NV (Infrared/IR) Mode.
Entering NV (Infrared/IR) Mode
First, enter LOCKOUT Mode by pressing and holding the Constant-On
and Cycle Control simultaneously for approximately 1.5 seconds until the
RED LOCK indicator illuminates.
To enter NV Mode, press AND HOLD the Constant-On and Momentary
Controls simultaneously for 2 seconds. The RED LOCK indicator will
illuminate and FLASH TWICE to confirm you have entered NV Mode.
Constant-On Control (NV Mode):
Press and release to activate IR LEDs
in Constant-On.
Cycle Control (NV Mode):
While operating the IR LEDs in Constant-On,
press and release the Cycle Control to select between three brightness
levels of IR output.
Momentary Control (NV Mode):
Pressing the Momentary Control while
operating in NV Mode will activate the IR LEDs at the maximum bright-
ness setting. Releasing the Momentary Control will turn the IR LEDs OFF.
Exiting NV (Infrared/IR) Mode
To exit NV Mode and return to visible light output, re-enter LOCKOUT
Mode as outlined above. Then enter Ready Mode by pressing the
Constant-On and Cycle Control simultaneously. The GREEN UNLOCK
indicator will illuminate signaling visible light is enabled.
POWER MANAGEMENT/LOW BATTERIES
The Tomahawk Tactical Light features three brightness settings to
extend battery life.
HIGH CONSTANT-ON WHITE OUTPUT –
2 hours
MEDIUM CONSTANT-ON WHITE OUTPUT –
10 hours
LOW CONSTANT-ON WHITE OUTPUT –
60 hours
When batteries are getting low, the red lock-out indicator will begin to
flash. This indicates that the light will lose the high setting within minutes.
This will repeat itself within the medium and low settings until the light
eventually fails to operate.
The ring of secondary LED's on the MC, NV, & LE models will continue
to operate for a short time after the battery power is too weak to run the
main LED.
However, after several minutes the ring of secondary LED's will
continuously blink and cannot be shut off using the buttons on the
keypad. Batteries must be removed and new ones installed.
Runtimes are approximate – and may vary depending on usage condi-
tions and quality of batteries used.
CLIP ADJUSTMENT
To adjust the MOLLE-ready Retention Clip, loosen the battery housing by
rotating it until the clip moves freely around. Once the clip has been
adjusted to the desired position, re-tighten the battery housing.
FIRST-LIGHT USA, LLC LIMITED WARRANTY
The PERIOD OF WARRANTY shall be three (3) years from date of purchase. First-Light USA will repair
or replace, free of charge, at First-Light USA’s option, any part due to defects in material or workman-
ship. First-Light USA may refund the purchase price if unable to repair or replace the product to perform
the work for which it was designed. The limited warranty contained herein is the purchaser’s exclusive
remedy.
THIS WARRANTY EXCLUDES damage or defects caused by neglect, abuse, misuse, alteration, disas-
sembly, improper maintenance or accidents. Batteries, or damage caused by defective batteries, are
excluded from this warranty.
WARRANTY IS NON-TRANSFERABLE and applies only to the original purchaser.
To obtain warranty service, call 877.454.4450 or send e-mail to [email protected]. First-Light
USA will then issue a Return Merchandise Authorization (RMA) and instructions on warranty return.
If we determine the remedy is not covered under this warranty, we will notify you and inform you of serv-
ice options available on a fee basis.
FIRST-LIGHT USA, LLC MAKES NO OTHER WARRANTY OF ANY KIND, EXPRESSED OR
IMPLIED. ALL IMPLIED WARRANTIES, TO INCLUDE BUT NOT LIMITED TO WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE WHICH EXCEED THE OBLIG-
ATIONS AND TIME LIMITS STATED IN THIS WARRANTY ARE HEREBY DISCLAIMED BY FIRST-
LIGHT USA, LLC AND EXCLUDED FROM THIS LIMITED WARRANTY. SOME STATES DO NOT
ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITA-
TION MAY NOT APPLY TO YOU.
ALSO EXCLUDED FROM THIS WARRANTY ARE ANY INCIDENTAL OR CONSEQUENTIAL DAM-
AGES INCLUDING LOSS OF USE. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITA-
TION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES; EXCLUSIONS MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER
RIGHTS THAT VARY FROM STATE TO STATE.
FIRST-LIGHT USA, LLC, WARRANTY AND SERVICE DEPARTMENT
205 S Main Street, Seymour, IL 61875
P: 877.454.4450 F: 877.454.4420 • [email protected]
2/2011
