First Light C-RED 2, Quick Start Manual

Page: 4 / 14

3. DISPOSAL
In case of disposal, do not throw your camera in waste disposal and send it back to
First Light Imaging
4. WARNINGS
General warnings
The equipment must be plugged on an electrical wiring compliant with the relevant standards in the country
(in France: NFC 15-100). This wiring must be protected from overcurrent, overvoltage and ground defaults.
Equipments connected must be compliant with the EN 60950-1 Ed.2006 standard, or to their own standards.
The power cable plug serves as a disconnection device and should be easily accessible.
Do not place the equipment close to a heating source or a humidity source.
Do not close the ventilation system to avoid any overheating.
The security of the system which integrates the equipment is the responsibility of the system assembler only.
For your safety, the equipment must be TURNED OFF AND UNPLUGGED before any technical intervention.
The security provided with this equipment is only guaranteed with a use in accordance with the specified
purpose. Only use the provided (XPPower, model AJM90PS12) power supply.
The use of a Polymer Lithium battery involves fire hazard which can seriously harm goods and persons. The
user fully agrees to accept the risks and responsibility.
The manufacturer and the distributor cannot be held responsible for any damage to goods and persons as
they cannot control the proper use of the battery (charge, discharge, storage).
IMPORTANT NOTE: For Switzerland: the annex 4.10 of the SR 814.013 standard is applicable to batteries.
5. TECHNICAL SPECIFICATIONS
Power supply
Voltage 100 – 240 VAC
Frequency 50 – 60 Hz
Current 1.5 A – 0.6A
Camera’s dimensions Length 143 mm
Width 74.91 mm
Height 55 mm
Operation conditions Maximum temperature 35°C
Humidity
80 %