15
Assembly
STEP 7
Tank Filling and Water Treatment
INITIAL WATER TREATMENT
Add 1 x Water Treatment Tablet per full tank. DO NOT, UNDER ANY CIRCUMSTANCE,
USE A WATER TREATMENT TABLET OTHER THAN THOSE SUPPLIED WITH YOUR UNIT.
Your unit purchase includes 4 x Water Treatment Tablets, which is sufficient for
several years of use. Refer to Long Term Water Treatment on page 17 for further
advice on maintenance.
Note: The Lower Black Tank Plug is Permanently Sealed.
a) Connect the rower to the power using the Power Supply[20] .
b) Press level + on the IPM or handle to change the level to 20
c) Unplug the Power Supply.
d) Filling requires a large bucket (not Supplied) and the supplied water
funnel and hose[5]. Filling will take approximately 8 liters of water.
e) Open the yellow fill plug on the back of the tank and insert hose
(rotating the impeller slightly may be necessary to allow the hose to
pass). Note: In areas where tap water quality is known to be poor,
FDF recommends the use of distilled water.
f) Move the Tank Adjuster Handle to Level 20 and begin filling
.
Do not
fill the tank higher than the level indicator on the front of the clear
shell.
g) Once filling is complete follow the water treatment procedure below,
then replace the tank plug.
Power Supply
CAUTION
Use a drop cloth under
the tank when filling to
avoid damage floor or
carpet.
Do not fill past the
calibration mark as
indicated on the tank
level sticker or water
spillage may occur.
WARNING
Impeller blades are
sharp! Do not Place
fingers in tank to
adjust impeller
position. It is
recommended to use
the end of the hose
Should the impeller
require adjustment.
Yellow Tank Plug
Filling Hose and Funnel
Summary of Contents for Vortex VX3 FA
Page 1: ...USER GUIDE...
