11
TO DO THIS FOLLOW THESE STEPS.
1.
Power on the console.
2.
Press and hold WORK and REST for 3+ seconds.
3.
The console will beep once and display the calibration screen.
4.
Set the Fluid Resistance to level 1 and wait a few seconds before clicking RESET.
5.
Set the Fluid Resistance to level 2 and wait a few seconds before clicking RESET.
6.
Set the Fluid Resistance to the next level and wait a few seconds before clicking RESET.
7.
Repeat #6 until all levels have been done (5 or 10 depending on Fluid Resistance Tank).
8.
When all levels are done the console will reboot.
9.
Check calibration by cycling through all resistance levels.
*The numbers below is a non realistic
example of calibration of a 10 level tank
FLUID RESISTANCE LEVEL CALIBRATION PROCEDURE
FDF - FLUID
POWER
ZONE - FLUID RESISTANCE TWIN TANKS
Calibration of the resistance level sensor should not be required under normal circumstances.
