E-4
•
If the pairing fails, turn off the receiver (slide the RECEIVER ON/OFF
SWITCH (#5 ) to the OFF position to reset the receiver. Repeat steps 3 to 6
to try again.
•
The LED INDICATOR (#3) on the receiver will continue to flash when it is
turned on.
HOW TO FIND THE LOST OBJECT
Attach one of the SFA200 receivers to an object like a set of keys, or something
else that easily gets misplaced. Press the COLOR CODED BUTTON (#2) on the
transmitter. The LED (#1) on the transmitter will turn on for about 4 seconds. The
receiver with same COLOR CODED MARKING (#4) as the button you pressed
on the transmitter will start beeping, and continue beeping for about 10 seconds.
NOTE : Do not press any other button on the transmitter when the
TRANSMITTER LED INDICATOR (#1) is ON.
BATTERY REPLACEMENT
Transmitter
•
Unscrew the three screws on the back cover and remove
the back cover of the SFA200 transmitter.
•
Carefully replace the battery with a new “CR1632” (or
equivalent) lithium button cell battery (replacement
battery not included). Insert the battery into the
compartment with the “
+
” side facing up.
•
Replace the back cover, insert the three screws and
tighten them. Be careful not to over tighten the screws and strip out the screw
holes.
Receiver
•
Unscrew the one screw on the battery door
located on the back of the receiver, and remove
the battery door.
•
Carefully replace the batteries with 2 new
“CR2032” (or equivalent) lithium button cell
batteries (replacement batteries not included).
Insert the batteries into the compartment with the
“
+
” side facing up.
•
Replace the battery door, insert the one screw and tighten it. Be careful not to
over tighten the screw and strip out the screw hole.
Note :
Clean the battery contacts and terminals in the device prior to installing new
batteries.
