E-1
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that
may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
CAUTION
Follow the advice below for safe operations
•
This product is intended solely for non-commercial & non-industrial use. Do
not use for any other purpose.
•
Do not immerse in water/liquid.
•
Do not press the Function Buttons with a ball point pen or any other pointed
object.
•
Do not expose the product to direct sunlight for extended periods.
•
To avoid damage to internal circuitry, do not expose the product to excessive
humidity or dust.
•
Do not drop the product or subject it to a strong impact.
•
Do not twist or bend.
ON CONDENSATION
•
When left in a heated room where it is warm and damp, water
droplets or condensation may form inside the unit.
•
When there is condensation inside the unit, the unit may not function
normally.
•
Let it stands for 1 to 2 hours before turning the power on, or gradually heat
the room up and dry the unit before use.
