6
5
6
Turn the dial left (counterclockwise),
at least 3 times, stopping on the
1 number at the index mark.
1 #
Turn the dial right
(
clockwise),
passing the 2 number once.
Stop on it the 2 time.
2 #
Turn the dial left (counterclockwise),
and stop on the 3 number. Now turn
the safe handle to open.
3 #
If combination is entered correctly, you will be able to easily turn the handle clockwise
and pull the door open.
Step 3
Step 2
Step 4
Step 1
–
Locate the combination printed on page 12 of Safes Identification Record.
–
Step 5
nd
nd
OPENING SAFE WITH COMBINATION DIAL
A. IF THE COMBINATION DOES NOT WORK, DO NOT CLOSE DOOR! Try
Again. Refer to the TROUBLE SHOOTING GUIDE on page 8 of this manual for
additional help.
CHANGING COMBINATIONS ON MANUAL LOCKS
It is inadvisable for anyone other than a CERTIFIED LOCKSMITH to change the
combination on a manual lock. Changing the combination by anyone other than a
certified technician will void the lock portion of your warranty.
The lock requires accurate alignment with the index mark (located at twelve o'clock position
on the dial ring). Always turn the dial slowly and steadily when entering your combination to avoid
dialing past your numbers. Never spin the dial rapidly back and forth as this may cause damage to
the lock. If you go past any number - even if by only a half a number - the entire combination must
be re- dialed. To verify your combination, follow the five steps below.
st
st
rd
rd
nd
1. Locate Metal Shelf
Clips inside the safe.
4. Carefully place shelf on top of the clips.
5. To remove clips, squeeze the clip with your hand or pliers and lift up.
2. Insert the top
of the clip into
the notch.
IMPORTANT
Four (4) clips are required for each shelf. Make sure all four (4)
clips are in alignment before moving on to step 4.
3. Push the bottom
of the clip into
the lower notch.
NOTE: Determine desired height and layout of shelves before you begin installation.
SHELF INSTALLATION
