Page | 9
Firgelli Automations
Email:
1-866-226-0465 Ext. 2
OPERATION
RESET:
The system has to perform a complete RESET in order to operate. The red signal light will flash at
0.5 second intervals indicating a RESET is required.
Press and hold the RESET button on the
Hand Controller
to lower lift all the way to the bottom. Once
the lift reaches the bottom it will then raise 7mm and the light shuts off indicating the RESET is
complete.
The RESET button must be held and cannot be released during the process. The LED light on the Hand
Controller will flash rapidly, when light turns off, it means the RESET is done.
Notes:
Before RESET procedure is completed; no buttons will function except the RESET button on the hand
controller.
Press and hold RESET button 5 seconds in order to activate the RESET procedure intentionally.
When the lift is moving, pressing RESET will stop its motion. If RESET is held for at least 5 seconds, the
system will enter the RESET procedure automatically.
STUDY:
Before using the
Remote Controller
, it is necessary to pair the remote to the receiver:
Press
+
on the
Remote Controller
as well as the STUDY button on the
Hand Controller
simultaneously and hold. The LED light will flash three times, which indicates studying is complete.
Release buttons when studying process is complete.
