3
®
95WIDISP-2 ONLY
1. Plug the 95WIDISP-2 ribbon cable connec-
tor onto the 9-pin receptacle in the 95DSS3.
Note: The ribbon cable can only be installed
one way. The two tabs on the ribbon cable con-
nector must face to the right (away from the RJ
connector), and the cable's blue stripe must be
on the on the bottom ( towards the two scanner
cable connectors).
2. Position the 95WIDISP-2 in the 95DSS3,
making sure that the notch in the rear of the
95WIDISP-2 aligns with the key in the 95DSS3
housing.
3. Install the second o-ring into the machined
groove on the outside of the 95WIDISP-2 (not
shown).
4. Install the threaded Locking Ring onto the
95DSS3 scanner.
The locking Ring must be very firmly torqued for the seal to be effective. A strap wrench or similar tool with a 12
inch minimum handle is recommended rather than installation only by hand
61-7347-1 ONLY
1. Position the 61-7347-1 Blank Cover in the 95DSS3 making sure that the notch in the rear of
the 61-7347-1 aligns with the key in the 95DSS3 housing.
2. Install the second o-ring into the machined groove on the outside of the 61-7347-1.
3. Install the threaded Locking Ring onto the 95DSS3 scanner.
The locking Ring must be very firmly torqued for the seal to be effective. A strap wrench or
similar tool with a 12 inch minimum handle is recommended rather than installation only by
hand
95DISP-1 Installed
95WIDISP-2 Installed
61-7347-1 Installed
