by the manufacturer. Discard used batteries safely according to
manufacturer's instructions.
WHENEVER THE BATTERY IS REPLACED,
TEST THE ALARM FOR CORRECT OPERATION
PUSHING THE TEST BUTTON.
WARNING: DO NOT USE ANY OTHER TYPE OF
BATTERY, EXCEPT AS SPECIFIED IN THIS
USER GUIDE. DO NOT USE RECHARGEABLE
BATTERIES.
1. Turn off power to smoke alarm at main consumer panel.
2. Insert a small screwdriver into the slot in the mounting plate. Depress
locking tab with the screwdriver and turn smoke alarm counter-clock-
wise to detach from mounting plate.
3. Gently pull down smoke alarm. Be careful not to separate cable
connections.
4. Pull out power plug from back of smoke alarm.
5. From back of smoke alarm, lift tab to open battery pocket door.
6. Remove battery from pocket. Disconnect and discard drained battery
from battery connector.
7. Connect a fresh, 9-volt battery to connector. The battery will fit only
one way. Be sure battery connector is securely attached to battery
terminals. Smoke alarm may sound a short beep when battery is
installed. This is normal and means the battery is installed correctly.
8. Place battery into battery pocket.
9.
Close battery pocket door.
Push down until it snaps into place.
10. Press and hold test button. The alarm will sound if the battery is
properly connected and working.
11. Replace connector plug. Connector will snap into place. Gently tug
connector to be sure it is attached properly.
12. Reattach smoke alarm to mounting plate by turning smoke alarm
clockwise until it snaps into place.
13. Turn on power and test smoke alarm using test button.
(For Models KF10R and KF20R only):
N
NO
OT
TE
E::
Rechargeable lithium batteries are permanently mounted and
sealed in the tamper-proof housing. These cells are designed to
last the useful life of the smoke alarm.
C
CL
LE
EA
AN
NIIN
NG
G
Clean the smoke alarm at least once a month
to remove dust, dirt, or
debris. Always turn off power to smoke alarm before cleaning.
•
Using the soft brush or wand attachment to a vacuum cleaner, vacuum all
sides and cover of smoke alarm. Be sure all the vents are free of debris.
•
If necessary, turn off power and use a damp cloth to clean smoke
alarm cover.
IMPORTANT:
Do not attempt to remove the cover or clean inside the smoke
alarm. THIS WILL VOID YOUR GUARANTEE.
R
RE
EP
PA
AIIR
R
CAUTION: Do not attempt to repair this smoke alarm.
Doing so will void your guarantee.
If smoke alarm is not operating properly, see “Troubleshooting”. If
necessary and if still under guarantee, return smoke alarm to Kidde.
Pack it in a well-padded carton and send, postage prepaid to Kidde
address at the end of this user guide.
If the smoke alarm is no longer under guarantee, have a qualified
electrician replace the smoke alarm immediately with a comparable
Firex smoke alarm.
PRACTICE FIRE SAFETY
If the smoke alarm sounds its alarm horn, and you have not
pushed the test button, it is warning of a dangerous situation.
Your immediate response is necessary. To prepare for such
occurrences, develop family escape plans, discuss them with
ALL household members, and practice them regularly.
•
Expose everyone to the sound of a smoke alarm and explain
what the sound means.
•
Decide on TWO exits from each room and an escape route
to the outside from each exit.
•
Teach all household members to touch the door and use an
alternate exit if the door is hot. INSTRUCT THEM NOT TO OPEN
THE DOOR IF THE DOOR IS HOT.
•
Teach household members to crawl along the floor to stay below
dangerous smoke, fumes, and gases.
•
Decide on a safe meeting place for all members to meet outside the
building.
6
!
!
1374-7205-00(KF10_KF20_KF10R_KF20R)_EN_V4:_ 2014.11.20 10:16 AM Page 6
