fireStorm SEQ18, User Manual

Page: 13 / 14

12 of 13
BATTERY CHARGE
The sequencer has 2 x 12V lead acid batteries installed.
Only use the supplied smart charger to charge the batteries.
The charge port should not be used to power the device directly.
The battery charger LED will flash orange when charging and steady green when battery is
full.
The unit may be switched on while charging. However, it is recommended to keep the unit
switched off to avoid false ‘end of charge’ detection.
We recommend to keep the batteries in good condition by avoiding very low discharge.
The battery voltage and firmware version are displayed on startup.
Note: Charge the battery every 3 months even if sequencer has not been used.
Note: The battery voltage should be above 23V for best operation.
SELF TEST ERROR CODES
The sequencer runs a self test on start up.
This may warn you of defects by displaying an error code.
Pressing OK will move past this error and allow operation of the sequencer.
PROCEED WITH CAUTION WHEN AN ERROR CODE IS SHOWN.
ERROR # DESCRIPTION
ERROR 01 ARM MOSFET stuck ON.
Sequencer will not be operational. Do not use.
Contact manufacturer for repair.
ERROR 02 Any channel MOSFET stuck ON. Bank with problem channel will flash.
Press OK to proceed.
Be aware that a channel(s) are PERMANENTLY ON and could fire as
soon as an igniter is connected. PROCEED WITH CAUTION .
Contact manufacturer for repair.
ERROR 03 Any channel MOSFET stuck OFF. Channel LED will flash.
Press OK to proceed.
Be aware that channel(s) are permanently off and may not function.
Contact manufacturer for repair.