riderite.com
9
SUP
AS-1
AS-2
EXH
SUP
AS-1
AS-2
EXH
ECU
1/8 NPT PUSH-TO-CONNECT
STRAIGHT FITTING
AIR LINE TUBE
AIR LINE TUBE
OPTIONAL: Install Air
Line Tube to the EXH
air fitting - 16” max.
Route to SUP
on ECU.
Route to AS-1
on ECU.
Route to AS-2
on ECU.
Route to EXH on ECU.
AIR LINE
TUBE
LEFT AIR SPRING
(when facing forward)
RIGHT AIR SPRING
(when facing forward)
AIR COMPRESSOR
* As a water/debris
trap. See page 4.
Create
loop in Air
Line Tube.
AIR SPRINGS
(sold separately)
INSTALL AIR LINE TUBES
5
DO
Make sure the cut is as square as possible.
Use a tube cutter or very sharp utility knife.
DON’T
Fold or kink the Air Line Tube.
Cut the Air Line Tube at an angle.
Use pliers, scissors, snips,
saws, or side cutters.
Square cut
90˚
AIR LINE TUBE
AIR LINE TUBE
AIR LINE TUBE
AIR LINE TUBE
PROPER AND IMPROPER CUTS IN THE AIR LINE TUBE
EXHAUST ALL AIR FROM THE SYSTEM PRIOR
TO RELEASING AIR TUBES FROM AIR FITTINGS.
5
PSI
1
Route the Air Line Tube from
1/8 NPT Push-to-Connect
Straight Fitting on the top
of the Air Compressor to
the Supply (SUP) air fitting
on the ECU, leaving room
to secure it safely. Use the
guidelines on page 4 for
proper Push-to-Connect
Straight Fitting install.
2
Repeat Steps 1 to route Air
Line Tube from the ECU to
the Air Springs. Use the
AS-1 and AS-2 air fittings
on the ECU.
3
If desired, install Air Line
Tube to the Exhaust (EXH)
air fitting to reduce exhaust
noise and prevent dirt from
clogging the port (recom-
mended for off-road or
dirty environments). Do not
exceed 16" of Air Line Tube,
and secure it so the end
turns to the ground.
