Encore Urban Wet
6
5. ASSEMBLY INSTRUCTIONS
1. Remove all outer packaging and timber.
2. Remove slotted steel top plates from rear of heater and set aside,
taking care not to scratch or damage the paint finishes.
3. Remove granite ashlip and door knob set from inside the firebox and
set aside, taking care not to scratch or damage it.
4. Position unit onto floor protector ensuring it complies with the
clearances as shown in section 4 on page 5.
6. Plumb in the wetback in accordance with accepted plumbing practises
– refer to section 7 page 8. Ensure the wetback is not pushed down or
comes into contact with the baffle bricks or flue gas deflectors. This will
cause premature wear to the wetback and will not be covered by the
manufacturer’s warranty.
5. Lift top casting and ensure baffle bricks and metal deflector are
correctly located as diagram below with DEFLECTOR PLATE
CENTRED and then replace top casting ensuring good seal down onto fire
rope bed.
REFER ITEM 5 - CHECK BAFFLE BRICK INSTRUCTIONS
Summary of Contents for Encore Urban wet
Page 10: ...Encore Urban Wet 10...
