4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation in
Fig. 4-1:
Flavor grids, cooking grids, backburner cover, warming rack, meat probe.
Leave pre-installed E-burners in place to maintain proper alignment.
Backburner Cover
(if equipped)
Hook the backburner cover over the top of the backburner to protect the
backburner from grease, dust and dirt when it is not in use.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner’s manual to remove or replace.
Shelf/Sideburner (if equipped)
Align the four (4) holes in the shelf with the four (4) holes in the side of
the cart while aligning and engaging the burner venturi with the orifi ce
(Fig. 4-2). Insert the four (4) screw (provided) into the holes and tighten.
Connect the spark wire to ignitor electrode (Fig. 4-2). Open sideburner
lid, set cap on burner, and set grid into shelf.
Screws
Ignitor
electrode
Air shutter
Orifi ce
Spark wire
Fig. 4-2
Venturi
Center main burner control knob
(A540s and larger only)
Fig. 5-2
Left
main burner
control knob
Right main burner
control knob
Backburner
control knob
(if equipped)
Digital
thermometer
Meat probe
Sideburner
control knob
(if equipped)
Drip tray
Fig. 4-1
Cooking Grid
Flavor Grid
(not with IR)
Backburner
cover
Warming
rack
Cotter
Pin
Rotisserie
rod storage
ring
Sideburner
lid
Note:
For infrared burner equipped
grills; see detailed instructions
included in your owners manual.
Meat probe
Drip tray
liners
Drip tray (with
lighting instructions)
Fig. 5-1 - Valve control knob
OFF
HI
LIGHT
LOW
T
O
TURN OFF
T
O
TURN
ON
Read setting
here
HIGH to
LIGHT
Read setting
here
To
Turn
OFF
To
T
urn
ON
High to
light
6-Propane Safety
Gas Cylinders
IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND IN
YOUR OWNERS MANUAL.
5-Test
1.
Open the lid and remove any cover(s) of the burner(s) to be lit. (Ensure grill connected
to power.)
2.
Turn all gas control knobs to the
OFF
position.
3.
Turn the gas-supply valve on.
4.
Depress the desired control knob, and while pressing turn it counterclockwise to the
HI
LIGHT
position. Once the burner lights, release the control knob. (Repeat this step for
each additional burner.)
CAUTION:
If burner does not light within 5 seconds,
IMMEDIATELY
depress the knob and
turn it to the
OFF
position. Wait 5 minutes before repeating step 4. If the burner
does not light after repeated attempts, refer to the Lighting Instructions in your
Owners Manual.
WHEN OPERATING THIS
APPLIANCE WITH PROPANE,
ALL INSTRUCTIONS AND
WARNINGS MUST BE
OBSERVED. FAILURE TO DO
SO MAY RESULT IN A FIRE
OR EXPLOSION CAUSING
SERIOUS INJURY OR DEATH.
Light
switch
Light
switch
REV 6 - 1311020955
L-C2-291
E-burner
*
(pre-installed)
*
The
burner ports
and
carry-over slots
must be kept clean to
ensure proper ignition
and operation.