23
Woodtec Freestanding
Issue 01.1 05/17
8.8
Maintenance of air control valve. The main air control valve is mounted
underneath the air plenum chamber which is immediately beneath the firebox
base. To access this for thorough cleaning firstly remove the base outside air box.
Invert the firebox for access. To remove the outside air box remove 4 x fixing
screws from the bottom of the firebox. Now remove locking nuts and springs
from the control lever and lift the slider off. Replacement is the reverse of
disassembly.
8.9
Adjusting Door Latch. The handle assembly may be adjusted on the door by
loosening the fixing screws and sliding up or down as required. For maintenance,
the internal cover over the roller latch inside the stove body can be removed
from inside the firebox. NOTE: ensure that the cover is fully sealed when
replacing this component because air leaks may occur if care is not taken.
8.10
External Air Kit fitting. Instructions come with the external air kit but as a general
guide the following can be used. Firstly unpack the contents of the external air kit
and locate the air box that needs to be fitted to the rear of the stove. Next
remove the rear casing of the stove. Remove the cut-out at the base of the rear
casing to allow it to be re-fitted once the external air box is in place. Fit the
external air box to the back of the stove as shown.