REV. 8-24-18 Page 5
PAVER-CP-TMSI
STEP 7:
Once the fittings and wired are installed into the TMSI valve bracket then insert the valve bracket into Paver Kit
Bracket as shown in Fig. 9.
STEP 8:
Secure the TMSI valve bracket into place using the (4) stainless thread cutting screws. See Fig. 10.
STEP 9: Conduct a trial burn test and check for any gas leaks before completing the installation. See install manual of
the fire pit or page 7 for lighting instructions.
STEP 10:
After burn test is complete, finish the patio paver block installation per the install manual.
Fig. 9
Installing TMSI valve into Paver Kit Bracket.
Fig. 10
Close up view
securing TMSI valve bracket to control panel.
Paver Block
Paver Block
