Firegear Outdoors All Weather Ignition System (AWS)
REV. C Page 10
PREPARING THE BURNER PAN FOR PILOT INSTALLATION
Power Screwdriver
Botto
m of P
an
Cover Plate
Fig. 8
Removing cover plate.
Removing the four screws from the existing cover plate
from the fire pit pan.
Note:
Retain the four screws to install
the new AWS ignition assembly later in this process.
Preparing the AWS-PLATE
In the parts box is an #AWS-PLATE. The plate has two
tabs and a large square hole. Orient the plate as shown in
Fig. 6. Uses a pair of needle nose pliers and bend the tab
closest to the square hole up 90°. See Fig. 7. Leave the
other tab as is, in the flat position.
Pilot M
oun
ting Holes
Tab bent up 90°
2-Tabs
Fig. 6
Shows AWS-PLATE in flat position.
Fig. 7
Show one tab bent upward 90°.
ALL PANS OR DISCS MUST BE REMOVABLE
FOR SERVICE
Pans or discs CAN NOT be installed in a
manner to prevent them from being removed
for service.
Top coping material or top cap of fire feature
MUST NOT overlap onto the pan or disc
surface. Pan lip or disc outer edge must be
be unobstructed so it can be lifted out of the
fire pit or fire feature for servicing.
