REV. 2-5-18 Page 23
Round Flat Disc Fire Pits
INSTALLATION OF BATTERY INTO TRANSMITTER
You have one handheld transmitter and you will need to install the included (12-volt battery) into the transmitter. On the
backside of the transmitter, push the cover away from the case. Place the battery into the compartment matching positive-
to-positive and negative-to-negative. To ensure the battery is properly installed push any button on the transmitter and
you will see a red LED light at the top of the transmitter glow. The red LED light will only be lit when a button is pushed.
IGNITOR ALIGNMENT
It is important check that the ignitor probes be properly
aligned overtop of the burner port holes and did not move
during shipping. Use the Fig. 24 as a guide. Before lighting
remove the screen cover of the ignition hood to burner and
ensure the spark probes are directly overtop of a burner port
hole. The sparking probes and the thermocouple must be in
the path of a flame to ignite the gas for proper ignition of the
flame. Replace the screen cover and follow the operating
instructions.
Fig. 24
Proper alignment of probes and thermocouple
.
Thermocouple
1/8” Gap at Ignitor Probes
Igniton
Hood
⅛”
SECTION C THERMOCOUPLE FLAME SENSE (TFS) INST
ALLA
TION
Fig. 23
Weatherproof Cover/Lid
Battery
Pack
Junction Box
Weatherproof
Cover/Lid
Battery Pack
Cover Plate
Rubber Gasket
Wires from
Valve Box
