REV. 8-24-18 Page 2
Flexframe
TWO AVAILABLE MODELS
FLEXFRAME-SS:
Constructed of 16 guage 304 stainless steel. Engineered to protect against the outdoor elements
including salt water environment.
DESCRIPTION:
Flexframe kit comes shipped in two pieces, 44-inches long. Each piece can be bent or cut to fi t any
shape (square, linear or round). It provides the means to support a fi re pit inside of an enclosure which enables a service
technician the ability to remove the media and easily lift the fi re pit out for service.
INSTALLATION
SPECIFICATIONS
6 ¼”
1 3⁄16”
7⁄8”
5 3⁄8”
Fig. 1
End view
STEP 1:
Determine if the Flexframe will work for your application. Measure the outer dimension of the fi re pit and
compare it to the inner dimension of the enclosure. The Flexframe protrudes outward approximately
⅞”
on the inside of
the enclosure to provide a lip to sit the fi re pit in place.
NOTE:
If an optional log set is purchased, additional support
(i.e. blocks stacked underneath the center of the fi re pit) may be required to support the extra weight.
STEP: 2
Refer to the installation manual of the fi re pit you are installing to ensure you maintain proper clerarances to the
ground. Lay the pavers or blocks to build your enclosure. When you have reached the minimum height (per fi re pit
manual) inside the enclosure install the Flexframe as shown in Fig. 2 or Fig 3. Ensure the Flexframe slides in as far as
possible until it stops at the fi rst bend.
READ THESE INSTRUCTIONS COMPLETELY THROUGH BEFORE PROCEEDING WITH INSTALLATION
Pavers
Flexframe
Pavers
Pavers
Pavers
Correct
Installation
Fig. 2
Correct Flexframe orientation
Pavers
Flexframe
Pavers
Pavers
Pavers
Correct
Installation
Fig. 3
Correct Flexframe orientation
