H- Burner Kit
REV. A Page 8
Before you begin installing the H-Burner into a burner pan ensure the center hole is 7/8” to 1-inch in diameter (See Fig.
6).
Ensure to seal the burner nipple and each NPT fitting with thread tape or pipe compound.
NOTE:
Flared
fittings will not require tape or compound on the flared side.
Step 1:
Install the H-Burner through the pan (See Fig. 4) then install the OAS and U3-8D-S to the nipple connect inlet
gas line as shown in Fig. 5.
7/8” to 1- Inch Center Hole
Fig. 4
Minimum center clearance hole in burner pan.
ALL H-BURNER MODELS
H-BURNER ASSEMBLY
CAUTION:
Do not assemble the OAS and U3-8D-S until you are ready to install the H-Burner into the burner pan. The
OAS is 1½” in diameter and would not fit the recommended center hole size per Fig. 6 and Fig. 9.
GAS FL
OW
H-Burner Side View
Burner Pan
U3-8D-S
OAS (Orifice)
Burner Nipple
Fig. 3
H-Burner Installed into Burner pan/disc.
