REV. B Page 8
Burning Spur Kit
INSTALLING KEY VALVE
The key valve contents: 1- key valve, 1- key and 1- flange. (See Fig. 6). The valve requires a 1¼” round clearance hole
in the non-combustible enclosure wall. See the instructions supplied with the key valve for more specific details.
Note
: Be sure to leak test all fitting before operation. Fig. 7 shows an example of a typical installation on page 8.
Primary Gas
Supply
ON
O
FF
Fig. 6
Key valve components.
Note:
It is recommended to use the key valve assembly provided in the Burning Spur kit. Otherwise, you will need to
provide a key valve for the installation.
GAS FL
OW
Burner Pan
OAS#
U3-8D-S
BURNING SPUR ASSEMBLY
Fig. 5.
Natural Gas Burning Spur parts
Minimum 7/8” Center Hole
The burner panfor the Burning Spur needs a center hole a minimum of ⅞ -inch in diameter. We strongly recommend
using a pan for any Propane or LP Gas installations. Once the Burning Spur is placed into the center hole of your fire pit
pan then install the orifice (OAS) and fitting (U3-8D-S) as shown in Fig. 5.
Note
: Use Teflon tape or compound rated for
gas to seal the threads.
Fig. 4
Installing burning spur into pan.
