The controls are located on the back of the unit near the
top. Figure 2 illustrates the location of the controls.
Once the unit has been properly connected to a ground
electrical outlet, it is ready to operate.
Note: ensure the house circuit breakers for the power
supply are turned on.
Operation from the Control Panel
Figure 2
1.
2.
3.
1
/
2/
3/
Control Panel
Operating Instruction
7
Power+Flame
HEATER I ON/OFF
HEATER II ON/OFF
“Power/Flame” Turn on this switch on
and the fireplace will be ready to work
and the flame will display.Turn off the
switch, the heater is turned off and the
flame will disappear (before plugging
unplugging at the outlet, turn off
and
the Flame/Power switch).
“Heat I On/Off” Switches the heater I .
for 750W with Heating and flame effect.
“Heat II On/Off ” Switches the heater II
1500W with heating and flame effect.
Note: Heat II will not work if heating I is in its off position.
