Fire Sense Bellante, Manual

Page: 5 / 18

- PREPARATION
Before beginning assembly, empty contents of carton and make sure all parts are present. Place all parts on a soft. level
surface for assembly. NOTE: It is best to use TWO PEOPLE to assemble this gas fire pit.
Estimated Assembly Time: 60 Minutes
I
DO NOT over tighten hardware!
Contact us for assistance: (866) 985-7877
I
www.wtliving.com
0
0
0
l,I
@
=
_,,
5
1
Hardware Used:
M
Stud (8x30mm) x 4
N
Washer/Spring Washer/Nut (8mm) x 4
T
Plastic Cap (M8) x 4
2
Hardware Used:
O
Stud (6x40mm) x 12
Q
Washer (M6) x 12
R
Spring Washer (M6) x 12
S
Nut (M6) x 12
Place Table Top
C
so underside faces up. Screw 4 Studs
M
into
the holes on the Table Top with Screwdriver
U
. Then carefully
turn the assembled fire pit base upside-down and align the holes
in the top of the Legs with the Studs in the Table Top .
Place the holes over the Studs and secure each with Washer/
Spring Washer/Nut N as illustrated. Tighten with Wrench V .
Then place Plastic Caps
T
over Nuts .
Assemble the fire pit base: Locate Door Panel D , three Side
Panels
E
, Door Frame Leg
F
, and two Support Legs
G
.
Screw Studs
O
into the holes in the sides of all four legs,
including the leg pre-assembled to the door. In the order shown
in the illustration, beginning with
Door Frame Leg
F
, join the legs
and panels together by fitting the holes on the sides of the Side
Panels onto the Studs installed earlier.
To secure the Legs to the Panels, place a Washer
Q
then a Spring
Washer
R
onto each Stud , then thread a Nut
S
onto each Stud .
Do not tighten the hardware until the entire base is assembled.
Then, firmly tighten all
Nuts with the Wrench
V
, but DO NOT
OVERTIGHTEN.
G