Fire Sense 60951, Owner'S Manual

Page: 13 / 18

13
Lighting
:
NOTE : For initial start or after any cylinder change, hold the control knob in for 2 minutes to purge air from all
gas lines before proceeding. NOTE: This heater has an Electronic Ignition and will require installation of 1 - AAA
battery. The battery should be installed by unscrewing the RED IGNITER BUTTON.
1. Turn the control knob to the “OFF” position.
2. Fully open the LP cylinder valve.
3. Turn the control knob counterclockwise to
small flame symbol (MIN).
4. Push control knob in and then push the RED igniter button to
ignite the main burner. Repeat until the burner ignites. Keep the control knob
fully pushed in for an additional 10-20 seconds after the burner ignites, then
release the control knob.
5. To increase the flame, turn the control knob clockwise toward the large
flame symbol (MAX). To decrease the flame, turn the control knob counter
clockwise towards the small flame symbol (MIN).
6. To turn the appliance OFF, turn the control knob clockwise to the OFF position.
7. Wait at least 5 minutes before attempting to re-light the heater.
8. Turn the gas cylinder valve to OFF or closed.
If you experience any ignition problems, please consult “Troubleshooting” on page 16.
Caution : Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning
of oils used in the manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT
produce thick black smoke.
When Heater is ON :
Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will display
tongues of blue and yellow flame. These flames should not be yellow or produce thick black smoke, indicating an
obstruction of airflow through the burners. The flame should be blue with straight yellow tops. If excessive yellow
flame is detected, turn off heater and consult “Troubleshooting” on page 16.
Re-Lighting
:
Note : For your safety, control knob cannot be turned OFF without first depressing the control knob and then
rotating to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to allow gas to dissipate before re-lighting.
3. Repeat the “Lighting” steps listed above.
Shut Down :
1. Turn control knob clockwise to OFF while depressing the knob.
(Normally, burner will make a slight popping noise when extinguished).
2. Turn cylinder valve clockwise to OFF and disconnect regulator when heater is not in use.
NOTE : After use, some discoloration of the emitter screen is normal.
OPERATING INSTRUCTIONS