STEP 10
Locate Telescopic Body section 4-2 (NOTE: It has a small machined hole at the bottom of the section—see Figure 11)
and slide Adjustable Table (Part 5) over the end of section 4-2 making sure the adjustable clamps on the table are
facing
DOWN.
Now locate Telescopic Body section 4-1 (NOTE: It has a large round hole at the bottom of the section—see Figure
12) and slide section 4-1 down into section 4-2 until you can see the small machined hole from section 4-2 through
the large round hole at the bottom of section 4-1 as shown in Figure 13. Insert 1 – M4*10 Round Head Screw into the
small hole and tighten. This will prevent section 4-2 from sliding completely out of section 4-1 when the assembled
pole is lifted.
9
SMALL HOLE
FIGURE 11
LARGE HOLE
FIGURE 12
FIGURE 13
Insert screw here and
tighten
