13
BRUSHES REPLACEMENT
Before replacing the brushes, extract the key from the control dashboard, this avoiding that any
accidental ignition of some motors could cause damages
•
First of all remove the knobs (fig.) by unscrewing them, then extract the brush covering carter
•
Rotate each brush until its knob (fig.) can be reached, then extract it and remove the brush fallen
on the ground.
•
To insert the new brush, place the hexagon of the female joint (fig.) under the male joint located
on the motor, then lift the brush vertically by rotating it until its automatic insertion has been
reached.
•
After placing the brushes, insert the carter and screw the knobs again.
Fig. 9
Fig.10
1.
Brushes covering carter knob
2.
Brushes covering carter
1.
Brush joint intake
2.
Brush release joint
