Finn EAGLE 244D, Parts And Operator'S Manual

Page: 13 / 38

9
AUXILIARY HYDRAULICS CONTROL:
This unit is equipped with two auxiliary controls. One is used for attachments that have a hydraulic motor
controlling them and the other one is used for attachments that are controlled with a hydraulic cylinder.
The auxiliary control lever that is on the right side of the machine (when facing forward) is the one used
to control attachments with a hydraulic motor. This lever is friction detented in both directions so as to
control the amount of oil that actually goes to the attachment. One direction will turn the motor forward
and one will turn the motor in reverse. This lever is not spring centered so it is necessary to manually move
it back to the center detent position which will turn the hydraulic motor that it is controlling off.
NOTE: The engine will not start unless this lever is in the center detent
position.
The auxiliary control lever on the left side of the machine is used to control attachments with a hydraulic
cylinder. This lever is spring centered to return to neutral when the lever is released. Pushing the lever one
direction will extend the cylinder while pulling the lever in the opposite direction will retract the cylinder.
LEAVING THE MACHINE UNATTENDED:
Whenever leaving the machine unattended, even if it is only for a few minutes, it is important that the
main lifting arms are returned to the ground as close as possible, depending on which attachment is on the
machine. Turn the ignition key to the “OFF” position to stop the engine. Be sure to remove the key from
the ignition switch and take it with you so that any unauthorized personnel cannot start the machine.
ATTACHMENTS:
The universal faceplate is designed to allow quick interchange with a variety of attachments. The attach-
ments are held onto the machine by two spring-loaded locking pins. These pins simply rotate 180 degrees
to lock and unlock any attachment. The following steps are the proper way to install any attachment.
IMPORTANT: Use only Finn authorized attachments. Other attachments may
change the stability and operating characteristics of the unit. The
machine warranty may be voided if unauthorized attachments
are used.
CONNECTING ATTACHMENTS:
1. Insure that the locking pins are in the unlocked position (pins facing inwards).
2. Start the engine.
3. Slowly tilt the universal load plate forward.
4. Move the machine forward so that the universal faceplate lines up with the adapter plate on the
attachment.
5. Once the universal faceplate is inside the adapter plate on the attachment curl the universal faceplate
all the way back and raise the loader arms slightly. The attachment should roll back onto the uni-
versal faceplate.
6. Turn the ignition key to the “OFF” position to stop the engine. Carefully step off platform to engage
the attachment lock pins.
7. Rotate the locking pins to the locked position (pins facing outwards). Make sure that the locking
pins are fully engaged by observing the locking pins sticking through the bottom of the adapter plate
on the attachment.