English
- 12 -
Using Side AV Connectors
You can connect a range of optional equipment to your
LED TV using side connectors of the TV.
For connecting a camcorder or camera , you should
•
use AV socket (side). To do this, you must use the
supplied audio/video connection cable. First, plug
single jack of the cable to the TV’s AV IN socket
(side). Afterwards, insert your camera cable’s
(not supplied) connectors into the plural part of
the audio/video connection cable. Colours of the
connected jacks should match (YELLOW for VIDEO
connection, WHITE/RED for audio connection). See
illustration below.
Camera
AV Connection
Cable (supplied)
AV Cable
(Not supplied)
Headphone
Afterwards, you should switch to
•
Side AV
source.
See the section Input selection in the following
sections for more information.
To listen the TV sound from headphones, you
•
should connect headphones to your TV by using the
HEADPHONE
jack as illustrated above.
Using Other Connectors
You can connect a range of optional equipment to your
TV. A possible connection is shown below. Note that
cables shown in the illustration are not supplied.
For connecting to a device that has SPDIF support,
•
use an appropriate SPDIF cable to enable sound
connection.
External Speakers
A device that
supports
SPDIF signal.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of
•
the handset by gently pulling backwards from the
indicated part.
Insert two
•
AAA/R3
or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it will not be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz.
•
Press STANDBY touch button. Then the standby
•
LED lights up.
To switch the TV on from standby mode either:
•
Press the “
•
” button,
P+
/
P-
or a numeric button on
the remote control.
Press the
•
-P/CH
or
P/CH+
touch button on the TV. The
TV will then switch on.
Note
: If you switch on your TV via PROGRAMME UP/
DOWN buttons on the remote control or on the TV
set, the programme that you were watching last will be
reselected.
To Switch the TV Off
Press the “
•
” button on the remote control or press
the “ ” touch button on the TV, so the TV will switch
to standby mode.
To power down the TV completely, unplug the
•
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.
