Finesse 2.0 OKIN, Manual

Page: 18 / 24

EN - Installation Finesse 2.0 OKIN
At the first use of a Finesse bed, the hand control is already paired to the receiver. The
hand control should function without any problem on this bed part. In case of a double
bed system, an extra Synchro cable (X-Cable) has to be installed for Synchro use. This
cable is included.
Connection Synchro cable - switching off/on Synchro Mode
At the receiver box, please remove the plug of the LED light. Instead connect the male
plug of the synchro cable. At the female plug of the synchro cable, please connect the
plug of the LED light.
This connection should be done on both bed parts of a double bed!!
Synchro can now be switched off and on. Please press the provided
Sync key 4
on the
hand control until you hear a BEEP. The synchro mode is now turned off. When turning
on synchro, all the bed parts move down until you hear the BEEP. The bed is now in
synchro mode.
When operating problems should occur after delivery, the connection between
remote control and receiver can be restored.
- First a reset of the receiver is required (factory settings).
Press 4 times the pairing button A , the LED in the pairing button lights up, then
press a
5
th
time . You hear a BEEP, the LED flashes and then turns off. The
RESET was successful.
- Next, press the pairing button on the receiver box twice, the LED lights up. The
receiver is now in pairing mode.
- Finesse 2 Mot. RSM: On the hand control, press the two keys 1 and 2 together as
indicated.
- Finesse 4 Mot. RSM: On the hand control, press the button 3 in the battery
compartment.
- When you hear a BEEP and the LED goes out, the connection was successful.
- Now, the system needs to do a Reference movement - both motors move to their
zero point. Please keep the pairing button
A
pressed until a BEEP is heard. Only
then the reference movement is completed.
- Now, the bed is ready for use.
Functions
Zero Gravity position - button Azzz: This is a position of back and leg at an angle of
about 28° for a most soothing posture.
Anti-Snore position - button Z: This is a position of back and leg at an angle of about
7° that reduces snoring.
Memory positions keys M1 and M2:
2M RSM - Press the programming button
5
until
it lights blue together with buttons M1 and M2 . When you then press the M1 or M2 key,
the current position of the bed is stored in the corresponding key. This is confirmed with
a Beep.