- 8 -
flash for 120secondss. Press any of the SET, MIN/MAX/- key or CH/+ keys to
silence the alarm. Press
ALARM
key to
enter the SNOOZE mode,
will
start flashing indicating that the alarm is active but in snooze mode.
The alarm
will sound again in 5 minutes.
If longer than 20s no key operation, the unit will switch itself to normal display
mode automatically.
5. Battery replacement
z
When the batteries of the outdoor sensor are used up, the low battery
indicator appears on the display
z
If battery change happened on remote sensor side, then the base station
must be powered up again to re-learn the transmitter.
z
Please use Alkaline Batteries, do not use rechargeable batteries. Please
take note of correct battery polarity.
Note:
Please participate in the preservation of the environment by properly disposing
of all used-up batteries and accumulators at designated disposal points. Never
dispose of batteries in a fire as this may cause explosion, risk of fire or leakage
of dangerous chemicals and fumes
6. Troubleshooting
Q 1.
No signal from remote sensor
A
There can be many reasons for this, the following steps should help you
troubleshoot this problem.
1.1 Make sure that the batteries in the remote sensor are not depleted.
1.2 Reduce the distance between transmitter and receiver
1.3 Remove the batteries from the base station and the remote sensor
and reset the weather station in the right order as described in section 2
of this manual.
1.4 This problem could also be a result of radio interference in your
neighborhood, try relocating the sensor and the base station
Q 2
Remote sensor drops off intermittently
A
Possible interference from other sources, try relocating the sensor or the
base station. Radio device operation on the same frequency can also cause
interference.
Q 3
Temperature,is incorrect.
A
Check/ Replace the batteries. Also make sure that the remote sensor is
not place near objects that can act as sources of heat or cold.
7. Specifications
