- 3 -
Note
: Please note the polarity when inserting/replacing batteries in the unit,
failure to do so may result in permanent damage. Use good quality Alkaline
Batteries and avoid rechargeable batteries.
1)
Open the battery compartment of the display unit and the transmitter and
place both instruments on a desk with a distance of approximately 1.5
meter. Check that no other electronic devices are close.
2)
Insert 2XAAA 1,5V Alkaline batteries first into the battery compartment of
the transmitter and immediately afterwards 2XAA 1,5 V in the display unit,
observing the correct polarity. When battery is first inserted, the red LED
light will be light up for 3-4 seconds. (If no LED light up or is lighted
permanently, make sure the battery is inserted the correct way or a proper
reset is happened)
2.2 Reception of outdoor temperature and RCC time
RF (Radio Frequency) Receiving mode
1.
When the base station is powered up, all LCD segments will light up for
about 4 seconds after the “beep”. The weather station begins to register the
outdoor transmitter, enter RF receiving state for 3mininutes
2.
Base station receive the outdoor temperature each 48s. If there is no new
effective signal from the sensor in constancy reception failure 6 times, the
outdoor temperature will displays “--.-“
3.
Do not press any key before outdoor sensor data received, otherwise the
outdoor sensor learning mode will be terminated.
4.
If the outdoor weather data is not displayed or if any key is pressed before
the weather station receives the signal, or when changing batteries you will
need to follow the battery installation procedure again.
Please wait 10
seconds before re-insert the battery again to make a proper reset for both
transmitter and receiver.
Battery
compartment
LED
light
Battery
cover