19
33) Wind speed alarm: 0-50.0m/s (default: 1.8km/h, disable)
34) Guest speed alarm: 0-50.0m/s (default: 3.6km/h, disable)
35) Light high alarm: 0 to 300000 (default: 200000lux, disable)
36) UVI high alarm: 0 to 15 (default: 10, disable)
Specifications
1) Indoor temperature measure range: -10 to 60C
2) Outdoor temperature measure range: -40 to 60C
3) Humidity measuring range: 10% to 99%
4) Wind speed measure range: 0 to 50.0m/s
5) Wind direction: 0 to 359 degree
6) Rainfall range: 0 to 9999.9mm
7) Light range: 0 to 300000.0lux
8) UVI range: 0 to 15 index (0 to 20000 w/m2)
Troubleshooting Guide
Problem
Solution
Wireless remote (outdoor unit) not
reporting in to console.
There are dashes (--) on the display
console.
Check the thermo-hygrometer-transmitter LED for
flashing. You must remove the radiation shield to view
the LED.
The outside sensor has an LED under the plastic, just
above the battery compartment. The LED will flash
every 48 seconds.
If the LED is not flashing every 48 seconds, Replace the
batteries in the outside thermo-hygrometer-transmitter.
If the batteries were recently replaced, check the polarity.
If the sensor is flashing every 48 seconds, proceed to the
next step.
There may be a temporary loss of communication due to
reception loss related to interference or other location
factors,
or the batteries may have been changed in the remote and
the console has not been reset. The solution may be as
simple as
powering down and up the console
.
1.
Make sure you have fresh batteries in the
display console.
2.
With the sensor array and console 10 feet
away from each other, remove the batteries
