Page 11
36”
30”
30”
17½”
25”
Technical Specifications
Multi-Lid Directions
1. Open fill cap and place garden hose into tank. Fill tank to desired gallon marker,
if marker is above the bottom of calibration container, stop before water reach-
es calibration container. This is done to help chemical mix better and keep
foaming of chemical to a minimum later.
2. Remove Multi-Lid and use calibration container to measure the correct amount
of chemical for the water being used.
3. Pour chemical into tank and tighten Multi-Lid back onto tank. If desired amount
of water was added in step 1, you are done. Be sure to press firmly on fill cap to
seal with Multi-Lid. If desired amount of water was not met in step 1, proceed
to step 4.
4. Open fill cap and place garden hose into tank. Add water to the desired gallon
marker. Close fill cap, pressing firmly to seal cap to Multi-Lid.
NOTE: If water and chemical has not mixed properly, use the pressure adjustment
control on the manifold to recirculate the mixture through tank.
Properly secure the tank to your utility vehicle, using tie-down or ratchet straps (Not Included).
Tank straps may be installed through the handles to help prevent straps from slipping off tank if
too loose.
Handles can be used to lift the empty tank in and out of the box.
Stay within your utility vehicle’s weight limits. This unit when filled with water weighs approxi-
mately: 505 lbs. Consult the owner’s manual for your vehicle.
There is a shut-off valve on the intake line. It is at this location so you can shut
off the flow of solution to access your system’s filter screen for cleaning.
Checking/Cleaning the sprayer’s filter/screen:
Start your pump and before it shuts off, reach down and shut the valve to
the ‘Closed’ position (lever is perpendicular to the flow of fluid), then shut
off your pump.
Unscrew the bowl of the filter to access the screen.
Remove the screen and clean as necessary. Replace when done and
reassemble the entire assembly.
Make sure the valve is turned to the ‘Open’ position before restarting your
pump.
