Fimap UP36, Use And Maintenance Manual

Page: 29 / 84

27
EN
WORK
To start working, proceed as follows:
1. Make sure the bag filter (1) is suitable for use and properly
inserted ( Fig.1 ) (read the chapter “MAINTENANCE”).
2. Make sure the vacuum motor intake air filter (2) is suitable
for use and properly inserted ( Fig.2 ) (read the chapter
“MAINTENANCE”).
13. Push the vacuum pipe inside the guide on the appliance body
( Fig.13 ).
14. Wind the vacuum hose around the lower (17) ( Fig.14 ) and upper
(18) support (
Fig.15
).
15. Wind the power cable around the lower (19) ( Fig.14 ) and upper
(20) support ( Fig.15 ).
16. Fasten the power cable by means of the tie attached to the cable.
3. Make sure the vacuum motor outlet air filter (3) is suitable
for use and properly inserted ( Fig.3 ) (read the chapter
“MAINTENANCE”).
4. Make sure the brush (4) is suitable for use and properly inserted
(
Fig. 4
) (read the chapter “MAINTENANCE”).
5. Plug the power supply cable into the mains socket.
6. Switch on the machine by positioning the main switch (5) to “I”
(
Fig. 5
).
ATTENTION: the vacuum motor will now start to work.
7. Press the handle release pedal (6) and recline the control handle
towards you ( Fig.6 ).
ATTENTION: as soon as the handle is in the working position,
the green light (7) on the brush head unit comes on ( Fig.7 ).
The brush motor will now start to work.
8. Proceed with the work.
ATTENTION:
if the control handle is positioned vertically
during the work the brush motor will stop while the Vacuum
motor will continue to work.
ATTENTION: if the vacuum pipe (8) is removed during work
( Fig.8 ), the brush motor will stop while the vacuum motor
continues to work.
12
20
11
2
6
1
5
18
11
14
17
13
3
7
19
15 16
4
8
9
1
5
13
12
4
8
10
2
6
15
11
3
7
14
ON