Fimap SMG130 S, Use And Maintenance Manual

Page: 23 / 48

23
PREPARATION OF MACHINE
ATTENTION: Make sure the brushes are correctly connected. If they are not,
the machine may not work properly.
ATTENTION: users are advised to always wear protective gloves, to avoid the
risk of serious injury to hands.
The phases which have been listed here refer to the assembly of the rear brush. Repeat for the front
brush.
ATTENTION: Pay attention to the direction of the brush bristles during assembly,
the cusp of the brush viewed from the above should be towards the front of the
machine.
27. SIDE BRUSH ASSEMBLY
Proceed as follows to assemble the side brushes:
1. Turn the main switch key (1) clockwise by a quarter of a turn (to position 1).
2. Lift the brush head unit by operating the knob, the selected working program must be "Transport"
(position A)
3. Turn the main switch key (1) anticlockwise by a quarter of a turn (to position 0).
4. Engage the parking brake
5. Grip the seat rotation uncoupling handle (1), move it forward as far as it will go
6. Rotate the seat support as far as it will go
7. Disconnect the battery connector cable from the machine connector
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector
8. With the brush-holder arm up, loosen the wing nut (2) and remove the washer (3).
9. Insert the brush in the hub housing, making sure the four pins are inserted in their seats on the brush
itself.
10. Insert the washer (3) and tighten the wing nut (2).
ATTENTION: users are advised to always wear protective gloves, to avoid the
risk of serious injury to hands.
The phases which have been listed here refer to the assembly of the left side brush. Repeat for the right
side brush.
1
3
2