20
PREPARATION OF MACHINE
24.
ASSEMBLING THE BRUSHES
To assemble the brushes of the brush head unit, proceed as follows:
1.
Check that the brush head body is lifted off the ground
2.
Turn the main switch key anticlockwise to the “0” position
3.
Engage the parking brake located on the left side of the machine
4.
Remove the key from the instrument panel
ATTENTION: During this operation, check there are no people or objects near
the brush.
5.
Turn the knobs (1) in an anti-clockwise direction
6.
Use the handle (2) to remove the right splash guard cover
7.
With the brush head up, insert the brushes in the plate housing beneath the brush head, turning them
until the three pins enter the niches in the plate itself; Turn until the pin is pushed towards the coupling
spring and is locked into place. The photo shows the rotation direction to hook up the right-hand brush;
for the left-hand one, rotate in the opposite direction.
ATTENTION: During this operation, check there are no people or objects near
the brush.
ATTENTION: Make sure the brushes are correctly connected. If this is not the
case, the machine could move in an irregular, sudden manner.
you are advised to invert the right and left-hand brushes every day. If the brushes are not new however,
and have deformed bristles, it is better to reassemble them in the same position (the right-hand one on the
right, and the left-hand one on the left), to prevent the different inclination of the bristles producing an
overload on the brush motor as well as excessive vibrations.
ATTENTION: users are advised to always wear protective gloves, to avoid the
risk of serious injury to hands.
25.
SAFETY BELT INSERTION (OPTIONAL)
The machine is equipped with a lap belt safety device which allows the operator to be anchored to the
driving seat.
To fasten the safety belt proceed as follows:
1.
position yourself on the driving seat
2.
take hold of the mobile part (1) of the safety belt
3.
wrap it around the abdominal area
4.
insert the mobile part (1) into the slot on the fixed part (2)
5.
release the belt to allow the seatbelt tensioner to roll the belt back up
To uncouple the safety belt press the button (3) and remove the mobile part (1) or push the rapid
uncoupling button (4)
2
1
1
3
4
2
