FILLING THE SOLUTION TANK
Before filling the solution tank, carry out the following steps:
1.
Take the machine to the usual place for filling the solution tank.
2. Carry out the steps necessary to secure the machine, see paragraph “MACHINE SAFETY” on page 14.
3. Unscrew the solution tank from the machine body (17) (
Fig.15
).
4. Fill with clean water, at a temperature no higher than 50°C and no lower than 10°C.
5.
After filling the solution tank with clean water add the liquid detergent to the tank in the concentration and manner indicated on the detergent
manufacturer's label. To prevent the formation of excessive amounts of foam, use the minimum percentage of detergent recommended.
WARNING:
protective gloves should always be worn before handling detergents or acidic or alkaline solutions, to avoid serious injury to
the hands.
ATTENTION:
always use detergents whose manufacturer's label indicates their suitability for scrubbing machines. Do not use acid or
alkaline products or solvents without this indication.
ATTENTION:
always use low-foam detergent. Do not use pure acids.
6. When the tank is full, repeat the operations in reverse order in order to reassemble everything.
ASSEMBLING THE ABRASIVE PAD
For packaging reasons, the abrasive pad comes disassembled from the machine (if requested on the purchase order), and must be assembled
on the brush head body by doing the following:
1. Carry out the steps necessary to secure the machine, see paragraph “MACHINE SAFETY” on page 14.
WARNING:
It is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the work to be carried out.
2. Lay the machine on the ground and place the pad you want to use on the bottom of the support (
Fig.16
).
ATTENTION:
Ensure that the green LED (15) on the battery charger lights up when you connect the battery charger base circuit to the
power(
Fig.13
). This LED indicates that the battery charger circuit is correctly powered.
ATTENTION:
Before inserting the battery into the charging holder, check that there is no condensation or other liquid in the dock that will
hold the battery.
6. Insert the battery into the slot provided in the charger, taking care to position the battery poles correctly (
Fig.14
).
ATTENTION:
The battery can only be inserted into the charger one way. Do not use force when inserting the battery.
ATTENTION:
Carefully read the battery charger use and maintenance manual delivered with the appliance, before charging the battery.
ATTENTION:
Check that, when inserting the battery into the base of the battery charger, the red LED (16) present on the battery charger
(
Fig.13
) turns on. This LED indicates that the battery is recharging.
7. Perform a complete battery charging cycle.
ATTENTION:
the red LED (16) remains on until the battery is fully charged.
ATTENTION:
The charger and the battery can be left connected to the power outlet. The red LED (16) lights up when the charger
occasionally tops up the battery.
ATTENTION:
the red charge status LED (16) does not provide any indication of the battery charge level.
ATTENTION:
The battery may overheat during the charging phase, nevertheless, this is normal and does not imply that there is a
problem with the battery.
ATTENTION:
If the battery used in this device is over-charged, this may present a risk of fire, explosion or chemical burns.
8. When charging is complete, position the main switch (14), on the base of the battery charger, to position “0” (
Fig.12
).
9. Disconnect the battery charger power supply cable plug from the mains socket.
ATTENTION:
To prevent damaging the power cable, disconnect the plug from the mains socket by directly pulling the plug and not the
cable.
10. Remove the power supply battery from the body of the charger base, remove the battery from the body of the appliance by moving it
upwards.
16