Fimap MY50, Use And Maintenance Manual

Page: 22 / 36

22
DAILY MAINTENANCE
28. CLEANING THE SQUEEGEE
The careful cleaning of the whole vacuum unit ensures better drying and cleaning of the floor as well as
a longer suction motor life. Proceed as follows for cleaning:
1. Check that the main switch of the machine is set to “OFF”
2. Make sure the battery connector is disconnected from the machine connector (battery-operated
versions)
3. Make sure the power supply cable is disconnected from the mains socket
4. Remove the suction hose from the squeegee nozzle (1)
5. Turn knob (2) clockwise
6. Extract the pin (3) from the slot on the squeegee connector
7. Extract the pin (4) from the slot on the squeegee connector
8. Clean well both the squeegee and the rubbers with a jet of water
If the front squeegee rubber is worn, vacuum will be poor and the machine will not dry the floor properly;
in this case replace it (see section REPLACEMENT OF FRONT SQUEEGEE RUBBER).
If the rear squeegee rubber is worn, vacuum will be poor and the machine will not dry the floor properly;
in this case replace it (see section REPLACEMENT OF REAR SQUEEGEE RUBBER).
ATTENTION:
Before performing any type of maintenance, turn the main
switch to "OFF" and disconnect the battery connector of the machine (battery
version), disconnect the power cord from the mains socket (electric version).
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions.
29. CLEANING THE SOLUTION TANK
1. Turn off the detergent solution tap.
2. Disconnect the clean water drainage tube (1) from its housing on the back right side of the machine,
and empty the tank
3. Remove the clean water filling filter (2) from the filling nozzle of the solution tank
4. Clean the clean water filling filter
5. Rinse the inside of the tank with a jet of water
ATTENTION: Before performing any type of maintenance, turn the main
switch to "OFF" and disconnect the battery connector of the machine (battery
version), disconnect the power cord from the mains socket (electric version).
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions.
1
2
4
3
1 2