ADJUSTMENT
AND
INSPECTION
MINNY 420-430-520
Doc. 10004810
Emesso dic - 06
Rev. 00
Pag.
5 di 6
Regulation touching of the brush
Check that the
round head screw
on the back side is adjusted
close to the flat upper face of the brush. The gap between the head
and the brush must be 1-2 mm maximum when the brush is hooked
and lowed.
Squeegee adjustment
1.
Adjustment of the lifting unit
-
Release the
lock nut
-
Screw the
threaded rod
in order to have the head of the rod just
outside the base of the fork (max 1 mm)
-
Lock the nut to fix the adjustment
2.
Squeegee adjustment
-
The rubbers should have an inclination of about 45° along all tje
squeegee length
-
To get the correct inclination act on the
knob
for the squeegee
height adjustment (left and right side separated).
-
To adjust the inclination use the
metal knob
and the fix the
adjustent and block the black plastic lock
hand wheel
.
Just outside the
base of the fork
about 45
°
Rear rubber
Front rubber
