CHOICE AND USE OF BRUSHES
POLYPROPYLENE BRUSH (PPL)
It is used on all types of floors which are hot water resistant (not more than 60
°
C). The Polypropylene brush is
nonhygroscopic and therefore conserves its characteristics even if working in the wet conditions.
NYLON BRUSH
It is used on all types of floors with excellent wear and hot water resistance (more than 60
°
C). The nylon is
hygroscopic and so, over time, looses its characteristics working on the wet.
TYNEX BRUSH
The brush bristles are charged with very aggressive abrasives. It is used to clean very dirty floors. To avoid floor
damages, work strictly only with the necessary pressure.
THICKNESS OF THE BRISTLES
The thicker the bristles are, the more rigid they will be. These ones are therefore used on smooth floors or with
small joints.
On uneven floors with deep joints it is recommended that, softer bristles, which enter more easily in depth, are
used.
Please bear in mind that, when the bristles are worn out and get too short, they will get rigid and cannot penetrate
anymore. As well as for thick bristles, the brush will begin to jump.
PAD HOLDER
The pad holder is recommended to clean glossy areas.
There are two types of pad holders:
1.
The traditional pad holder is equipped with anchor points which allow the abrasive pad to be held and dragged
during the work process.
2.
The pad holder is of the CENTER LOCK type, apart from the anchor points, is equipped with a central blocking
release system made in plastic. This allows a perfect match with the abrasive pad and to hold it without the risk
of falling down. This type of pad holder is recommended especially for machines with more brushes, where the
centering of the pads is difficult.
LIST FOR THE CHOICE OF THE BRUSHES
Machine
Q.ty
Code
Bristles type
Thick
∅
Brush
∅
Lengt
h
Notes
C130B
4
4
1
4
66818010
66818020
66818030
66718010
PPL
TYNEX
PPL
Pad holder
1,4
1,5
345
345
300
335
1100
CYLINDRICAL
CENTER LOCK
62
