37
DAILY MAINTENANCE
42.
CLEANING THE BRUSH (BB VERSIONS)
To ensure effective floor cleaning, proper cleaning of the brush is necessary. In order to do this, proceed
as follows:
1.
Make sure the recovery tank is empty, otherwise empty it completely.
2.
Check that the squeegee body is raised above the ground; if not, lift using the lever (01) on the rear of
the machine.
3.
Make sure that the main switch (02) is in the "II" position; if not, position it to "II".
4.
Put the machine in rest mode. Using the control handlebar (pushing downwards), lift the front part of
the machine so that the rear wheel rests on the floor.
5.
Press the dead man's lever under the control handlebar and simultaneously activate the brush release
lever (03) positioned at the rear of the machine. As soon as lever (03) is activated, release dead man's
lever under the control handlebar.
WARNING: If the brush does not release, repeat the operation again until the brush
is released from the brush head.
WARNING: During this operation, check there are no people or objects near the
brush.
6.
Rinse the brush carefully under running water.
7.
Read the paragraph “ASSEMBLING THE BRUSH” before reassembling all components.
WARNING: This operation must be carried out using gloves to protect against
contact with dangerous solutions.
43.
CLEANING THE SQUEEGEE BODY
The careful cleaning of the whole vacuum unit ensures better drying and cleaning of the floor as well as
greater duration of the vacuum motor.
Proceed as follows for cleaning the squeegee body:
1.
Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position “0” (valid for versions BB).
1.
Switch off the power supply to the machine's electrical system using the main switch (01) located on
the rear of the machine, turning the key to position “0” (valid for versions B-BT).
2.
Disconnect the electrical connector (02) from the battery connector.
3.
Engage the parking brake by means of the lever (03) on the right side of the machine (only for BT
versions).
4.
Lower the squeegee body by means of the lever (04) on the back of the machine.
