21
INITIAL START-UP AND USE OF THE MACHINE
7
1
3
2
8
80-90-110-100-120 B-D-Bifuel
3 Take the debris hopper (7) back and place the unloading
mouth as low as possible.
4 Slowly open the lid to allow collected debris unloading:
80-90-110: pushing the lever (3) down.
100-120: Pushing the lever (4) forwards.
After emptying, use the hatch lever to close it.
For safety reasons, the hopper can only be lowered by pressing
the green button (8) on the front instrument panel with your right
hand, and simultaneously using the hopper lowering lever (5)
80-90 -110 - (6) 100-120.
After bringing the debris hopper back to its working position,
reopen the hatch by pushing the lever (3) 80-90-110 (4) 100-
120.
At this point, you can carry on working.
ATTENTION:
before emptying the debris hopper, close
the lid by activating the lever and make sure that there
are no people in the machine working area.
ATTENTION:
with debris hopper up, move the machine
very slowly. maximum speed 1km/h. Avoid unloading
the debris while the machine is on a slope. Do not
activate the filter shaker when the hopper is raised.
After emptying, use the hatch lever to close it.
3. FRONT VACUUM HOSE KIT
To use the optional front vacuum hose kit, proceed as follows:
1 Engage the parking brake.
2 Get off the machine, go to the front of the machine and
remove the cover plate (1) located at the front of the debris
hopper.
3 Remove the front vacuum hose from the support.
4 Fit the flange in the vacuum hose (2) into the front part of
the debris hopper.
5 Activate the suction turbine using the appropriate command
(3); remember to activate it at maximum power.
6 Vacuum the dirt.
ATTENTION:
please note that when using the front
vacuum hose, it is compulsory to close the door of the
debris hopper.
