3.
Use
3.1
Commissioning
- Put the controller into operation only if the installation and the
electrical connection have been done correctly.
3.2
Normal operation
- Use the controller in its intended application only.
- Comply with the specifications
- If the controller is damaged, disconnect it immediately.
- It is forbidden to make changes to the device. This violates the
Normative.
3.3
Inexpert handling
- Ignoring the Safety instructions and the Operating instructions.
- Not intended use.
- Making changes or handling the controller.
- Violation against applicable Law and Standards.
- Using of non original parts.
4.
Maintenance, servicing and spare parts
4.1
Maintenance
- If used correctly, no specific maintenance is required.
4.2
Servicing
- Check and review the state of the housing, the probe and the
correct commutation of the electrical contact, as well.
4.3
Spare parts
- There are no spare parts for this controller.
5.
Storage
- Store the controller in a dry and dust-free environment.
6.
Disposal
-
- The controller can be recycled.
- The disposal applies to the valid environmental Guidelines
according to the location of the carrier and the local
manufacturing conditions.
on the data plate and the technical
data of this manual.
Switch off the power supply, before disconnecting the device.
2.2
Mechanical connection
The device can be mounted horizontally or vertically depending on
the model.
The normal installation is by screwing the device onto the deposit
wall, with a mounting flange or
2.3
Electrical connection
Connection diagram
with an appropiate support to fix it.
Level selector:
To connect the device or the level selection
adjustment, take out the cap of the DIN connector and, if it is
necessary the sealing gasket. Turn the selector to detect high or
low level:
High level detection:
Selector in position FSH. For high level
detection, the relay is disengaged when the probe is covered
of product or there is no supply. Red LED switched off.
Low level detection:
Selector in position FSL. For low level
detection, the relay is disengaged when the probe is
uncovered of product or there is no supply. Red LED switched
off.
- Fasten the DIN connector after making the electrical connection.
- Fix and fasten the screw of the DIN connector to ensure the
water-tightness.
DIN connector
ILV-660
04
Talleres Filsa, S.A.U.
www.filsa.es
•
•
•
•
•
E-08100 Mollet del Vallès (Barcelona)
Tel.
+34 93 570 46 01
Fax
+34 93 570 24 71 [email protected]
10/15
MI-ILV660-EN-04
© by FILSA
LED
Level selector
[
Terminal
1
2
3
4
PNP
+24 V DC = 3
+ of load
+24 V DC
[
NPN
- of load
= 4
+24 V DC
[
ILV660-003
1
3
2
4
FSL
FSH
1 2
1 2
1 2
1 2
ILV660-004
High level detection (FSH)
Low level detection (FSL)
LED
Relay
LED
Relay
Emptying
Filling
Empty
Full
Deposit
Deposit
FILSA constantly strives to improve its products and reserves the right to modify designs, materials and data without prior notice.
Keep this manual for further questions!
