Fillmaster Auto™ | User Guide
6
Operation
1.
Flush filters before first use. For Reverse Osmosis systems:
Flush the first tank of water. See install guide for complete
instructions.
2.
Plug in machine for power, turn on/off switch to “ON” position.
Both are located under the top cover.
3.
Secure SD card in the slot. Slot is located under the top cover
towards the back (machine will come with SD partially inserted
but only operates if SD card pushed in completely).
4.
Be sure that the water supply is turned on at all valves.
5.
Attach the dispensing tip.
6.
Purge the dispenser. To begin purge, press “Menu” on the
touch screen, then select “Manual Operation” and manually
enter 100ml. Collect water and repeat until water runs clear.
Repeating is common.
7.
Calibrate the unit. See instructions on how to calibrate the
unit.
8.
Install flavor bottles in machine. See instructions below on how
to install bottles.
Getting
Started
1.
Press “Menu” on the touch screen.
2.
Select “Calibration.”
3.
Place a graduated cylinder under dispensing tip and enter in
amount measured. Repeat until 50mL is measured.
How to
Calibrate
Getting started with
your Fillmaster Auto
1.
Press “Menu” on the touch screen.
2.
Select “Replace Bottle.”
3.
Choose the flavor you would like to replace and follow the
instructions on the screen (enter in expiration date, lot #, &
confirm).
4.
Once confirmed, the door will open. Insert bottle in
corresponding slot.
Note: Make sure cap is aligned with groove in slot.
5.
Wait until you hear the bottle click in and repeat with other flavors.
How to
Install Flavor
Bottles
Fillmaster® Systems, LLC
9475 Gerwig Lane,
Columbia, MD 21046
1-8
00
-
884
-
5771
•
www.
fi
llmastersystems.com
