FSM-IP NVR
Installation and Operation Manual
Revision Date: June, 2019
P/N 06-521 (Rev. 3)
7
5.0 FSM‐IP NVR software
Your FSM‐IP NVR comes loaded with the NVR software and preconfigured with the appropriate amount of
video storage banks. The software is designed to automatically start when the server is turned on. If power
is lost to the server, the server is configured to start up and the server software will automatically run when
power is returned. The default IP address of the server is 192.168.0.1 with a sub mask of 255.255.255.0.
Depending on the desired IP address scheme, the camera(s) and NVR IP addresses may need to be changed
to communicate. Once the Fike Video Analytics IP cameras have been configured with their unique IP
addresses and installed to cover the hazard area you can install and configure the NVR server.
The FSM‐IP NVR server should be installed in a secure and suitable environment. A suitable environment
would be an environment free of excessive dust, moisture, vibration and the extremes of heat and/or cold.
Slide Rails are provided to rack mount the NVR in a server cabinet. The cameras are then attached to the
server through a CAT 5 or greater cable through the Local Area Network (LAN).
To configure your FSM‐IP server you will need to set an appropriate IP address so you can communicate
with the Fike Video Analytics IP cameras and add the camera channels to the servers devices file. The
devices configuration file identifies what camera(s) the NVR should be looking for and then records the
video feed and alarm information from the specified cameras. To change the servers IP address, select the
Control Panel
from the
Start
menu. In the
Control Panel
select
Network Connections,
Figure 3, and right click
on
Local Area Connections
and select
Properties,
Figure 4
.
Figure 3: Network Connections Window
