FIK-RA2000 Product Installation Instructions —
P/N LS10261-001FK-E:A 03/03/2021
3
2.2 Surface Mounting
1.
Remove the desired knockouts. See Figure 3.
2.
To properly mount the backbox, insert a single screw into the key shaped mounting hole. Do not tighten all the way. See Figure 5.
Place a level on top of the backbox, with the backbox level, insert the rest of the mounting screws.
.
Figure 5 Backbox Surface Mount Holes
3.
Connect the wires from the FIK-RA2000 to the SBUS connectors on the FACP. See Figure 7.
4.
Use the FIK-RA2000TR Ring Trim Kits when you surface mount.
Place the trim ring over the backbox as shown in Figure 6.
.
Figure 6 Trim Ring Installation
5.
Attach the annunicator/door assembly to the backbox Use the screws provided. (See Figure 4).
6.
Replace the electronic assembly in the backbox.
3 Wiring Connections
Wire the FIK-RA2000 to the FACP as shown in Figure 7.
Figure 7 SBUS Connections
3.1 Installation
1.
Ensure the power is turned off at the panel.
2.
Mount the FIK-RA2000 in the desired location.
3.
Connect the FIK-RA2000 to the panel (see Figure 7).
4.
Use the DIP switches on the back of the FIK-RA2000 to assign an ID number. (See FACP manual).
5.
Add the FIK-RA2000 module to the System through programming. JumpStart
®
will automatically add the module to the System.
key shaped
mounting hole
backbox
mounting holes
FIK-RA2000
